I can set it to aggressively remove the clicks in the quiet passages where they are more noticeable, and then back off so I don't affect the music transients when things get busy. During very loud, ‘raucous’ passages, I set it very low.ĭoing it this way, I can clean up an entire album in about 15 minutes or so. I usually end up sliding it higher to clean all the clicks during the quiet lead in to a song, then reduce it as the music starts building in intensity. If you decide it is stopping too often on false detects of music transients, then you can slowly raise the 'Declick' setting until it quits getting false detects, or at least gets a reasonable number of them. This will cause the program to stop very often to highlight a suggested repair. The nice thing about this method is that you can set the 'Declick' setting on the fly. If you decide it is not a real click, then select 'Resume', which will start processing again without applying the repair. It will then apply the repair and start processing again until the next time it identifies a repair that exceeds the 'Automatic to' setting. If you decide it is a click, then click 'Accept'.

False triggering on the rapid rise of a music transient seems to be the most common place for Clickrepair to show a false repair. If it is in a more constant passage, then it is a click. If the suggested repair is at the beginning of a music transient, then it is not a real click. A key clue is to look at the top display. After some practice, it is easy to tell by looking if the repair is a real click or if it is due to a music transient that should not be repaired. But for larger repairs (more than 10 consecutive samples), it will stop with the suggested repair highlighted. This means it will automatically fix anything that involves less than 11 consecutive samples to repair. I use less than 10 with a 24/96k recording. It's been a while since I've done one, so I may not have all the terminology correct, but basically you set the 'Automatic to. I have also done an entire album by editing purely manually with an editor (Goldwave), but now I have settled on using the 'semi-automatic' mode with Clickrepair. I started trying to find automatic settings that worked for an entire album, then just for an entire song, but I gave up even on that.

Clickrepair dele settings